Electronics & Automation

Electronic train lighting and automatic train control units
A useful box pack containing a motor and gearbox assembly with a 9 piece gear set, control switch and wiring, steel wire and brass tube.
This set of components can be used for a multitude of purposes providing movement and animation to otherwise static features. The card wrapper provides a step-by-step guide to building the unit as a slow-action point motor as one suggestion and a useful assembly primer.

Ideal for operating items such as points, semaphore signals, water mills and level crossing gates in slow motion on Model Railways - or anything else your imagination and ingenuity allows. A great introduction to creating electro mechanical models!
£9.95
Warehouse: 1
Stroud: 1
Fast delivery from Warehouse.
(Product Ref 90196)
Gaugemaster Model 100 - Panel Mounted Single Track Controller 100
Single Track Panel Mount Controller for small gauges up to ˜OO. Input: 1 x 16v A.C. at 1.25 amps Requires T1, M1 transformer. Output: 1 x 12v D.C. at 1 amp controlled
Measurements: Panel: 70mm x 105mm x 28mm deep
Aperture: 43mm x 83mm x 25mm deep.
£39.95
Warehouse: 1
Fast delivery from Warehouse.
(Product Ref 24099)

Power controller designed specifically for use with large gauge models including gauge 1, G scale and LGB.

Output up to 20 volts DC

£99.95

Bristol: 1
Delivery from stores takes a few days longer!
(Product Ref 46809)

A time controlled unit which can be used with any controller and stops a locomotive at a point on a line, reverses it and then stops it again at a second point, reversing the locomotive again. This repeats indefinitely. The duration of each sequence can be adjusted from approx 20-70 seconds.
Input: 16v A.C. at a maximum of 1.25 amps Requires T1, M1 Transformer
Measurements: 109mm x 68mm x 20mm

£36.95

Will be ordered - delivery as soon as possible.
(Product Ref 42012)

A small unit providing an automatic stop and start facility which only requires one reed switch to be installed.
The locomotive decelerates for about 5 seconds after passing factory set. The time stopped can be adjusted from approx 20-70 seconds, the rate of deceleration is also adjustable.
Reed switch and magnet are included.
Input: 16v A.C. at a maximum of 1.25 amps Requires T1, M1 Transformer
Measurements: 109mm x 68mm x 20mm

£41.95

Will be ordered - delivery as soon as possible.
(Product Ref 45362)

Four Track Panel Mounted Controller for ‘N’, ‘OO’ and most small Gauges
Input: 4 x 16v A.C. at 1.25 amps each Requires 2x T1 or 2x M1 Transformer
Output: 4 x 12v D.C. at 1 amp each controlled
Measurements: Panel: 217mm x 105mm x 28mm deep
Aperture: 84mm x 190mm x 25mm deep

£94.95

Will be ordered - delivery as soon as possible.
(Product Ref 38382)
Have a question? Contact us
Wiring for layouts and electrical components can be found in the electrical section of our tools and hardware range.

Please note that these automation and high-frequency accessories are designed for use with DC control systems only. These devices are not for use with DCC systems.