Electrical Accessories

Hornby style Bullet pin connectors for wire termination. Ideal for use witrh Hornby point control levers and track feed connectors.

A 16v Power supply is required to power this Vollmer 7mm Smoke Generator

Use this switch to control the polarity on the N Gauge Code 55 SL-E383F Scissors Crossover. See Shows You How Booklet Wiring the Layout No 21 for a comprehensive colour coded diagram.

Link wire for connecting two tracks together. Ideal for conversion to DCC.

EZE-Wire Point Motor Switch Box.
For simple wiring & operation of 1 to 5 Model Railway point motors. For use with a suitable power source of 12-24volts.
WARNING: This product is intended for use with a suitable Model Railway controller with an output of 12-24V. Under no circumstances should it be connected directly to Mains Current - for indoor use only.

Single Pole On/Off Switch. Use this to control features such as lighting circuits, or as a section switch where only 1 controller is used.

For switching power on & off to control track power sections or lineside accessory lighting.

Many modellers like the extra realism that sound can bring to a layout but until now, this has often been an expensive and complicated feature to add, usually requiring DCC and quite a lot of space. SFX needs none of this and can work in any train.

Gaugemaster GM16 Pin Ended Connecting Leads

Clip this unit either side of an insulation gap on Peco H0/00 track. This can be used to isolate a loco at the end of a terminal road or siding, thereby enabling another loco to take the stock out. This is available as a ready made item in the Peco 00 Setrack range (ST-205/2005).

Pair of power connection leads with push-in pins at one end. Ideal for connecting controllers to Hornby pin connection power clips.

Using a clearbox gearbox this motor and gearbox drive unit has been designed for motorising model railway turntables. The easily dismanteled and re-assembled gearbox allows the gear ratio to be altered, providing a steady state speed from 625rpm down to 2.6rpm, with actual speed variation achievable using a speed controller eg. using the train controller switched to supply the turntable motor.

Final drive shaft diameter 4mm. Input cvoltage 1.5 to 6 volts. Wiring diagram included.

Single Pole On/On Switch. Use this to switch power from one device to another or for operating items such as 2 aspect colour light signals.

Motor drive unit suitable for use with Peco turntables in all scales including N, OO, HO, HOm, O-16.5/On30/On2½ and SM32. The smooth, silent running motor is designed to attach easily beneath the turntable pit mouldings of the Peco turntables and conversion of other turntables (eg Dapol kit) should also be straightforward.

Many modellers like the extra realism that sound can bring to a layout but until now, this has often been an expensive and complicated feature to add, usually requiring DCC and quite a lot of space. SFX needs none of this and can work in any train.