Track fixing pins are suitable for all gauges.
Please take care to select the correct gauge when ordering track underlay rolls.
For OO and N Gauge
Recommended for N Gauge Track
Blackened mild steel pins, 14mm (9/16") long. For fixing most Streamline track gaugesï¿½to wood fibre board (Sundeala) or similar baseboard surfaces.
Note that these are fine pins, not nails and cannot be driven with a hammer. We recommend drilling through sleepers with a 0.5 or 0.7mm drill. When using plywood or chipboard continuing drilling into the board to get the pin started. The pin can normally be driven home with a small hammer.
For OO/HO Gauge
A 5-metre roll of foam ballast underlay for use with Peco Setrack and Streamline track systems.To fit points cut the ballast roll down the centre and fit each side around the outer tracks of the point until the tracks part sufficiently to allow full-width ballast underlay to be used. Cut off square to meet and join the full width underlay. Use spare half-width underlay lengths trimmed along the outer edges to fit and fill the gap between the tracks.
25-gram bag of thick type track fixing nails, similar to the Hornby track pins.Approx 400 pins in each bag.
For OO Gauge Track
A flexible polymer foam pre moulded to fit most OO/HO track with real granite stone, recesses are clear to take sleepers.
For N Gauge Track
A flexible polymer foam pre moulded to fit most N gauge track with real granite stone, recesses are clear to take sleepers.
Large head brass track fixing pins. Suitable for most scales and gauges. Ideal for soldered track contruction. Approx 500 pins in each pack.
Note that these pins are too large for securing N and smaller gauge track by piercing a sleeper, please use SL14 track pins instead.
This is a very useful track alignment tool designed to keep the same distance between the centers of adjacent parallel tracks.
The tool is marked with scales in metric and imperial units with the track centre adjustable between 50mm/2in (used for parallel main tracks) and 105mm/4.1in, allowing space for platforms to be built between the tracks.The parallel track tools can be used on straight and curved track, the tools will fit curves of any radius.
One set includes 2 Tools
Perfect ballast spreading is never problem again with this easy to use Ballast Spreader.
The spreader is a hopper type device with slots underneath to deposite ballast into the centre of the track and on either side. The entire unit can be slid along the track, leaving behind an even layer of ballast between the sleepers.
Pack of 6 lengths of code 60 flat bottom rail. Length 609mm/24in.Flat bottom rail section (left)A 1.57mm 0.062inB 0.76mm 0.030inC 1.24mm 0.049inRail can be used with IL-120 OO scale conductor rail insulator chairs.
Update your browser to view this website correctly. Update my browser now